html - Catalog FORMAT plus - 2017 - 2018

Varieties and geometric description of milling inserts

416

P M K N S H

Finishing at high cutting speeds, best machining results, no vibrations

01

Copying and milling at high cutting speeds, good machining results, with small to medium chip cross-cutting

10

Copying and milling at medium cutting speeds, for medium to slightly adverse chipping conditions

Cutting Tools 2

20

Copying and milling at medium cutting speeds, and adverse chip conditions (break in cutting)

Toughness

30

Wear resistance

Copying and milling at low to medium cutting speeds, and extremely adverse working conditions (break in cutting)

40

Milling at very low cutting speeds, extremely adverse working conditions (severe breaks in cutting)

50

Carbide, coated PK 9115 Al 2

0 3

CVD coating, main application area is in groups P and K, only dry processing, high cutting speeds PVD coating, main application area is in groups K and H, wet and dry processing, high cutting speeds PVD coating, main application area is in groups P and K, wet and dry processing, medium to high cutting speeds and feed rate

KH 9105 Al 2

0 3

PK 9125 Al 2

0 3

PK 9140 Al 2

0 3

PVD coating, main application area is in groups P and K, wet and dry processing, medium to high cutting speeds and feed rate

KNH 9110 Al 2

0 3

PVD coating, universally applicable, wet and dry processing, high cutting speeds, with good machining conditions for operations with high thermal loads

PMK 9130 TiCN

PVD coating, main application area is groups P and K, sometimes also M, wet and dry processing, medium cutting speed combined with good wear resistance and toughness Gradient PVD coating with increased resistance to oxidation, universal use, dry and wet processing, very good gliding properties, medium cutting speeds with low to medium chip cross-cutting, used in poor machining conditions PVD coating, universal use, dry and wet processing, good wear resistance with good operational reliability, medium cutting speeds, also for poor operating conditions PVD coating, very tough grade, universal use, 1. Optional for processing in group M and P with heavily interrupted cut. Wet and dry processing, low to medium cutting speeds, combined with good wear resistance and toughness, for operations with higher mechanical load on the cutting edge

U

9135 Al 2

0 3

U

9035 Al 2

03

U

9145 TiCN

Carbide, uncoated N 9120 Ultra-fine grain uncoated, main application area is in group N, highly polished to prevent edge build-up

Geometries F =

Clamping stage for finishing - easy cutting

M

= =

Chip breaker for medium machining - universal application

R

Chip breaker for roughing

AL = VA =

Chip breaker for machining non-ferrous metals, brass, copper alloys and plastics

Chip breaker for machining stainless materials and super alloys

2/162