Catalog FORMAT Plus- 2017 - 2018

559

COOL FLASH Cooling taken to extremes

According to the motto "Making the Good Even Better", HAIMER has developed the new COOL FLASH SYSTEM for shrink-fit holders on the basis of the existing Cool-Jet. The coolant lubricant emerges through several slots, slides along the cutter and cools to the cutting edge of the tool!

Systems

Clamping

3

COOL-FLASH advantages: • Optimum jet guidance to the cutting edge • Up to 100% longer life • No more balls of chips on the tool • Even at high speeds • Optimum spinning! No longer out of balance! No disturbing contours! • Low cost and subsequent installation is possible

The seat belt for your tools

In high-performance cutting (HPC) it can happen that the tool is pulled out of the chuck. This is due to a slow micro creep motion. It occurs during machining with high torque and high attractive forces. Even chucks with extremely high holding force cannot prevent micro creep. This can turn high quality workpieces into scrap. The SAFE-LOCK™ -system provides a remedy. Driver elements in the chuck engage in grooves on tool shank. In addition to the frictional clamping forces of the shrink fit chuck, the tool is held positively. Thus, micro-creep is effectively prevented and your tool holds.

Safe-Lock TM advantages: • For high-performance clamping

• Highly accurate tension due to shrink technology • High torque due to positive transport technique • No loss in accuracy • No stripping of tool • No damage to workpiece and machine • The groove at the milling shaft is designed in a manner that the milling tool is pulled into the chuck

(depending on the turning direction) • Patent registered: licensing possible

3/37

Articles marked ◊ are not held in stock, procurement is effected at short notice.